Woo-hoo! I drilled the hole for the dial door knob and installed the knob. There are actually 2 knobs and they are interchangeable. The one I put on is the one I like. My wife likes the other one. Maybe I'll try that one later. Then I set the glass into the door frame and fastened with 3 screws. Then I puttied the glass to the door frame [messy work]. Then, I installed the 2 dial door hinges. And all fits perfectly. You may recall that I had already performed a run-through earlier this month. It tuns out, the glass is quite wavy. Perhaps it just doesn't look that way when it's close to the dial. Then, I put the hood assembly back on the case. I had planned to put the movement back on the seatboard today, however, that will wait until tomorrow, April 1st. I started the clock project back in April 2015 when I bought the clock movement. So it is fitting that I will be wrapping up the project in April 2016. It's been fun all the way through except for my whacking my thumb on the router [still hurts!]. Enjoy the slideshow below! Thanks for visiting!
AuthorI hope that you enjoy keeping up with my clock's progress! Archives
June 2016
Categories |